Ideas to Cover Popcorn Ceiling by House Painter Toronto

Textured ceilings, often called popcorn or cheese ceilings, are often the target of dissatisfaction with many homeowners. Builders or gypsum board installers mainly benefit from popcorn ceilings because this finishing method reduces dirt and sanding. Because it takes time and money to achieve a glass finish, builders will make ceilings for their benefit.

Removing the texture or the ceiling itself, covering the texture with a second layer by a house painter on the ceiling is another option.

Cover Popcorn ceiling with drywall cover

Summary: 1/2 inch or 1/4 inch drywall installed on the existing popcorn-textured ceiling drywall

Explanation: Since you already have drywall on the ceiling, why not add another layer below it?

As the home is reshaped, it is often easier to cover up the problem area than to completely remove and replace the area. The floor is usually covered by a second layer.

Covering an existing ceiling with drywall means you don't have to worry about asbestos or lead paint, which is usually included in texture and paint.

Cleanliness is also an advantage. Since you will not pull out the drywall, you do not need to deal with a large amount of attic insulation, debris, and pest dung when the drywall is lowered, which will rain inside the house. You can also contact the house painter in Toronto to get better quality of drywall installation.

Advantage

· Cheap price: You only need to buy low-cost drywall and screws.

· "Peeling" with drywall is the only concealed option that can cover a smooth ceiling.

· Of the three cover-up methods listed here, if you put your house on the market, this is the least likely method to jeopardize your resale value. Because it is a traditional ceiling, almost all potential buyers will accept it.

Disadvantages:

· Adding another sealing layer will increase the total weight of the ceiling.

· Thicker ceilings make it difficult to install recessed lights and junction boxes because their connection clips usually cannot accommodate thicker materials.

· In the elevator without drywall, the gypsum board is extremely difficult to install. A half-inch drywall, even ultra-light drywall, is still too heavy to be managed by one person. You need to rent a dry lift or need the help of two other people. Quarter-inch drywall is lighter but equally clumsy. In addition, because it is thinner, it is easier to break during handling.

Cover the ceiling with prepared ceiling planks

Introduction: Covered with fiberboard planks specially made for this purpose. Planks are laid on the edge of the strip.

Description: Woodhaven ceiling as a substitute for removing popcorn ceilings, etc.

The thickness of these MDF ceilings is a tongue, and each is 5 inches by 84 inches thick.

For best results, you may want to use the Easy Up grid system. Just like the traditional ceiling grid, it can keep all panels stable and orderly.

But unlike the ceiling grid, the grid is not visible. The circuit board is connected to the outside of the grid through a snap-in clip.

If the drywall is flat, the Woodhaven ceiling can be installed directly on the drywall.

In addition, attach a grid of waterside strips (1 x 2 boards, available in most home improvement centers). Although this allows you to fill the grid to full level, you will also lose some of the ceiling height from the added water seal layer.

Advantage

· The planks fit perfectly.

· The optional grid system is advantageous if you have a severely distorted or damaged ceiling.

· No need for dyeing and finishing.

Disadvantages:

· This system is the most expensive option listed here.

· Availability is limited. Chances are, you won't find it on the shelves of your local household goods retailer. Usually, it is a special order item.

Ceiling with tongue and ceiling pine ceiling

Introduction: Individual natural wood pine boards are purchased at the lumber yard or home improvement store.

Explanation: As an alternative to expensive ceiling systems, why not install something cheaper on your grid? This DIY method uses low-cost wood found by local retailers. Most home improvement stores have tongue and groove cork (such as pine or fir) that you can nail directly to the water edge strip.

Advantages:

· Although no ceiling covering can be considered cheap, this is the cheapest option listed here.

· This option allows the most styles because the wood can be dyed and finished to your specifications.

Disadvantages:

· If you don't have a truck, it will be difficult for you to transport wood because it is beneficial to buy the longest planks.

· Long planks are usually not very straight and need to be adjusted to make them fit.

Alternatives to cover popcorn ceilings by a house painter

If you are not interested in any cover-up options, there is one other method: remove the popcorn itself or remove the entire ceiling by the house painter.

Remove popcorn texture

Lay the floor with plastic boards. Climb up the ladder. Scratch off the popcorn texture. Pile up the plastic and throw it away. Paint the ceiling.

In a perfect world, it should be so easy, but often it is not. Removing the popcorn ceiling texture brings its own set of problems.

First, assume that the texture contains asbestos. The removal of these materials even requires special care. Hiring an asbestos removal company is expensive. On the other hand, removing popcorn is a lot like scraping paint: assuming that easy slices indicate that the rest of the surface area is deceptive.

One area is easy to fall off, while other areas are so difficult that you are shaving the cardboard to remove it.

On the other hand, removing popcorn can provide you with the maximum ceiling height. For highly challenging areas, such as basements, with counts per inch, you may want to remove the texture for the reason.

Contact today the Popcorn Ceiling expert in Toronto for any kind of ceiling removal or repair services in Toronto.

Search This Blog

Mas Construction - Painter in Toronto